PDA

View Full Version : need recplacment body panals



Bear
02-11-2007, 02:42 PM
other than shermanparts who else sells panals for second gen chevy vans?

leadfoot
02-11-2007, 04:19 PM
what do ya need i may have a piece or two
after my chop gets done

[This message has been edited by leadfoot (edited February 11, 2007).]

weard-harold
02-11-2007, 04:56 PM
I have a left side section O.E.M and a 1/4 patch panel O.E.M http://i43.photobucket.com/albums/e390/mrorganic/4c_1.jpg http://i43.photobucket.com/albums/e390/mrorganic/48_1.jpg

weard-harold
02-11-2007, 04:59 PM
By the way they are new. not used the rust is from sitting in a body shop for over 30 years it will sand off clean no dents large panel is $175.00 small is $80.00 that is what i paid for them

Bear
02-11-2007, 05:20 PM
here is what i see it needs.both rockers,passanger rear not rusted but looked wavey like a bad dent repair.drivers frount in frount of door stoop rusted out.passanger side perfect.you know on my 68 i got two dime rust holes where the winsheld leaked in the door stoops.on this 70 only driver side leaked. the winshield and dash no leaks.at one point in time someone skim coated.the whole van and sticked sanded it.the only draw back was they drove it on dirt roads here in michigan he had it for 15 yrs.

Joe Russin
02-11-2007, 09:34 PM
Bear, try Mill Supply
http://www.rustrepair.com/app2/onlinecat.htm?r=ms&p=sm

........Wookee