OK, now remove the switch assembly from the dash and let it hang down.
You will notice two purple wires going together into one socket on the plug on the back of the headlight switch. These purple wires go to the front parking lights.
http://turboninjas.com/gallery/d/52877-2/DSC07975.JPG
Pull the plug off the headlight switch and set the switch aside. Your headlights will go off now so you don't drain your battery.
The plan is to remove the purple wires' spade connector out of the hol that it is currently in and install it in the blank hole in the center bottom of the plug... next to the orange wires.
http://turboninjas.com/gallery/d/52877-2/DSC07975.JPG
Turn the plug over and using a very small flat blade screwdriver or a small poker tool, release the little holding tab on the spade connector. This tab holds the connector into the plug. The hole on the plug is shaped kind of like a top hat. you want to work your small screwdriver into the smaller top portion of the hat, this is where the little tang on the spade connector is. You can push in on the purple wires as you work your screwdriver into the hole to try and get the little tang to release. Once it releases, the purple wires and their spade connector should pull easily out of the plug.
http://turboninjas.com/gallery/d/52881-2/DSC07977.JPG
Once you have removed the spade connector with the purple wires out of the hole, use your mini screwdriver or poker tool bend the tang out a little bit, so it will lock into the plug when you re-install it in the new hole.
http://turboninjas.com/gallery/d/52883-2/DSC07978.JPG
Recent Forum Posts
