Vintage Chevy Van Club - Powered by vBulletin
  • Register
  • Help
  • Home
    • Home
    • Membership
    • Join VCVC
    • Early Registry Project
    • Club Store
    • Resource Center
    • Evants
    • Linkage
    • A Van's Life
  • Forum
  • Blogs
  • Advanced Search
  • Home
  • Home
  • Welcome To The Vintage Chevy Van Club Website!
  1. Please log in to view forums. Thanks, VCVC
  2. If this is your first visit, be sure to check out the FAQ by clicking the link above. You must register for the community forums register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

  • Welcome To The Vintage Chevy Van Club Website!

    by
    smiley
    • View Profile
    • View Forum Posts
    • Private Message
    • View Blog Entries
    • Visit Homepage
    • View Articles
    Published on 06-23-2013 06:05 PM
    If this is your first time here, take a second to register to view and post in our club forums, blogs, and gallery.

    Any questions or comments? Send an email to info@vcvc.org.

  • Recent Forum Posts

    van-itti

    Strange issue after a few months of Covid hibernation.

    Thats my whole life.
    I decide to run the yellow and the guy in front of me decides not to.

    van-itti 04-23-2021, 09:23 AM Go to last post
    madillow

    Strange issue after a few months of Covid hibernation.

    If the bowl is not getting full of fuel due to a clog in the needle and seat or a sticking float, it's possible that when you stop fast, the fuel sloshes

    madillow 04-22-2021, 11:55 PM Go to last post
    tinlizard

    Spindle question

    Seems like it. Although I suppose different bushings might accommodate 2 different king pin diameters in the same hole. But I recall the G10 bushings

    tinlizard 04-21-2021, 10:44 PM Go to last post
    Vanner68

    Spindle question

    The king pin kits are two different part numbers, G20 uses a larger pin. So, I would say the beam is different.

    Rare parts G20 kingpin set

    Vanner68 04-21-2021, 03:18 PM Go to last post
    tinlizard

    1965: Don't Buy a Van Made by Car People!

    I was on a project with Chevrolet commercial vehicles in the late 90s. in a meeting with some mid level brass, one of them revealed that GM's new strategy

    tinlizard 04-21-2021, 08:59 AM Go to last post
  • Contact Us
  • VCVC News
  • Archive
  • Top
All times are GMT -5. The time now is 12:26 PM.
Powered by vBulletin® Version 4.2.5
Copyright © 2021 vBulletin Solutions Inc. All rights reserved.