• Early Chevy Special from Vans and Trucks Magazine, 1975

    Club member Eric Frahm sent me his Vans & Trucks Magazine issue from 1975. It features a 25-page early Chevy section. I scanned it nearly 3 years ago and finally got around to laying it out in a downloadable PDF format for your enjoyment.

    Thank you again, Eric, for sharing!


  • Recent Forum Posts

    madillow

    Strange issue after a few months of Covid hibernation.

    If the bowl is not getting full of fuel due to a clog in the needle and seat or a sticking float, it's possible that when you stop fast, the fuel sloshes

    madillow 04-22-2021, 11:55 PM Go to last post
    tinlizard

    Spindle question

    Seems like it. Although I suppose different bushings might accommodate 2 different king pin diameters in the same hole. But I recall the G10 bushings

    tinlizard 04-21-2021, 10:44 PM Go to last post
    Vanner68

    Spindle question

    The king pin kits are two different part numbers, G20 uses a larger pin. So, I would say the beam is different.

    Rare parts G20 kingpin set

    Vanner68 04-21-2021, 03:18 PM Go to last post
    tinlizard

    1965: Don't Buy a Van Made by Car People!

    I was on a project with Chevrolet commercial vehicles in the late 90s. in a meeting with some mid level brass, one of them revealed that GM's new strategy

    tinlizard 04-21-2021, 08:59 AM Go to last post
    tinlizard

    Spindle question

    Is the actual axle beam different on the 3/4 ton (6 lug) from the 1/2 ton (5 lug) vans? Maybe you (CanVanMan) could just swap out the steering knuckle/spindle

    tinlizard 04-21-2021, 08:47 AM Go to last post