• Vintage Chevy Van Club. Since 1998.

    The VCVC is a community of Vintage Chevy Van owners, a resource center for Early Chevy Van parts and information, and is one of the largest active van clubs in the world today. With members in nearly every state and five countries, the Vintage Chevy Van Club represents early Chevy owners, worldwide.

    The club became official on January 1998, and the Vintage Chevy Van Club's site was launched that same month. With no specific focus on vintage vans of any make up til that time, the club began to establish a very loyal membership of vanners from around the country.

    Whether you have one Chevy van, a dozen earlies, or no vintage van at all; if you are in love with the 1964-1970 Chevrolet G-Series Van, you just found home.
  • Recent Forum Posts


    Need tips and tricks on tidying up engine wires.

    What do you mean by "dedicated circuit, bypassing the OE harness"?

    Say for example if i want to install new fog lights. How do

    monkeykongking 06-16-2019, 01:07 AM Go to last post
    65 Van Guy MKE

    Figured it out!

    I guess the o-ring goes into a groove on the top side of the carrier bearing. (Researching other sites) I got the driver's side together easily but once

    65 Van Guy MKE 06-16-2019, 12:30 AM Go to last post
    65 Van Guy MKE

    Starter fixed. For the next few years anyway

    I actually took the solenoid apart a while back and flipped the disintegrating contacts around to the unused side. Then I cleaned the coating of copper

    65 Van Guy MKE 06-16-2019, 12:07 AM Go to last post
    65 Van Guy MKE

    Side note

    And a side note to everyone who wants to quit after one kingpin because the other side seems fine... I was one of you, but I figured if I'm pulling the

    65 Van Guy MKE 06-15-2019, 06:59 PM Go to last post
    65 Van Guy MKE

    Kingpin replacement

    I got my front end apart!!! It was a nightmare that ended when I bought a 12 ton press from Harbor Freight. Now that I'm onto reassembly I have a couple

    65 Van Guy MKE 06-15-2019, 04:15 PM Go to last post