• Vintage Chevy Van Club. Since 1998.

    The VCVC is a community of Vintage Chevy Van owners, a resource center for Early Chevy Van parts and information, and is one of the largest active van clubs in the world today. With members in nearly every state and five countries, the Vintage Chevy Van Club represents early Chevy owners, worldwide.

    The club became official on January 1998, and the Vintage Chevy Van Club's site was launched that same month. With no specific focus on vintage vans of any make up til that time, the club began to establish a very loyal membership of vanners from around the country.

    Whether you have one Chevy van, a dozen earlies, or no vintage van at all; if you are in love with the 1964-1970 Chevrolet G-Series Van, you just found home.
  • Recent Forum Posts


    Comming Back Out...

    AC is definitely a bonus. Enjoy those rides. Both vans look real nice.

    66BeachCruiser 04-19-2019, 01:06 AM Go to last post

    Upgrading Cam

    Yes. I bought new lifters and camshaft bearings with the Camshaft. I was worried after several failed start up attempts that I was going to cause some

    66BeachCruiser 04-18-2019, 11:09 PM Go to last post

    Upgrading Cam

    I took your advice Wookie, and put JB Weld on it. Should fully cure over night and I'll paint over it tomorrow. Hopefully that keeps that crack sealed

    66BeachCruiser 04-18-2019, 10:58 PM Go to last post

    69 g20 resurrection.....

    Mark 108vanguy thanks for emailing me all your thoughts..without you guys(panelmanrd..thanks for the rear door parts!) this van would not be running!!

    kesojf 04-18-2019, 10:01 PM Go to last post
    Leroy Jackson

    Upgrading Cam

    I had a cylinder head crack inbetwwn two exhaust ports. JB weld fixed it for a good few years until I tossed some new heads on it. Blew the motor up shortly

    Leroy Jackson 04-18-2019, 09:56 PM Go to last post