Search:

Type: Posts; User: mimmell

Search: Search took 0.01 seconds.

  1. Thread: Side mirror

    by mimmell
    Replies
    14
    Views
    1,097

    Would you please share the part numbers?...

    Would you please share the part numbers? Interested in updating the mirrors. Thank you.
  2. You all called it. Pulled the engine up out of...

    You all called it. Pulled the engine up out of the dog house and the clutch plate was a little low. I used the tool but didn’t have it aligned to the center line of the crank. Re aligned it and it...
  3. Thanks everyone, very useful information. I will...

    Thanks everyone, very useful information. I will give it a go later today.

    Happy New Year to you all.
  4. I did use the alignment tool.

    I did use the alignment tool.
  5. Tip or tricks for mating engine to manual trans?

    1968 G10, 3 on the tree

    I have been working on getting my new 350 power plant mated up to my 3 speed. For the life of me, I can't seem to get the last inch of distance closed between the motor and...
  6. Replies
    4
    Views
    291

    Alternator/Header question

    Evening everyone. I am wanting to put headers on my 68 v-8 and realized the current mount is tied into the drivers side exhaust manifold. Does any have a reasonably budgeted solution for this?
    ...
  7. Replies
    3
    Views
    601

    Some experience

    I have been in software for over 20 years, working with DB’s for most of it. I am not an admin by trade but have a fair amount of database experience.

    Thanks!
  8. Replies
    14
    Views
    1,829

    Apologies for the delay, finally got around to...

    Apologies for the delay, finally got around to posting some pictures, oriented correctly this time. Here is a few pictures of the setup:
    41879

    The radiator mounts up as normal and mounts well....
  9. Replies
    7
    Views
    809

    Local welding shop straightened it out and I went...

    Local welding shop straightened it out and I went ahead and threw some paint on it. Going to be repainting everything under the van as I go along.

    Thanks for the help.

    41832
  10. Replies
    7
    Views
    809

    Thanks for the heads up, I did figure out...

    Thanks for the heads up, I did figure out yesterday after a bit of head scratching and double checking that the drivers side has reverse threads. Also, wasn't planning on using heat to straighten it,...
  11. Replies
    7
    Views
    809

    Steering rod replacement - 1968 G10

    Hey everyone, I am having trouble getting the drivers side tie rod out and the shaft that the tie rods connect to is bent.

    Any chance there is a replacement out there or should I be going to a...
  12. Replies
    14
    Views
    1,829

    2nd Gen replacement radiator

    I recently bought a 1968 G10 and am making some incremental improvements. The radiator looked to be the original. The plan was to upgrade it so I can put in a beefier engine down the road.

    The...
  13. Replies
    11
    Views
    1,438

    Found a solution

    Thanks for responding, I found a good solution.
  14. Replies
    11
    Views
    1,438

    Do you have a parts number(s) of this setup? ...

    Do you have a parts number(s) of this setup?

    Thanks! Like the setup.
Results 1 to 14 of 14