If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must register for the community forums register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
A lot of meat left...1 set was cut once, the other set has never been cut, neither set needs to be cut before use. A little fine sandpaper clean up and they are ready for use. Ill get some pics the next time Im at my shop. At $10 each + shipping...the buyer is getting the deal...I just need to send off the parts I wont be using.
The door rods and arm rests are long sold. I don't know how to remove the pics from the thread...sorry. Im sure somebody here can help you. Try Derrick Feole, He has tons o parts for sale.
The door rods and arm rests are long sold. I don't know how to remove the pics from the thread...sorry. Im sure somebody here can help you. Try Derrick Feole, He has tons o parts for sale.
Which 2 rods do you need? I just pulled a set out of my rear door. (driver's side) upper and lower are different lengths. 1st gen and second gen should be the same.
I bought my armrest from NPD (National parts depot) 1st gen. part # K-16155-64A. They have other parts for trucks that fit our Vans.
1966 Sportvan Deluxe 230 3 on tree (work in progress) Now 283 small block
1965 Sportvan Deluxe 250 powerglide (Sold)
1966 GMC Handibus Custom 350 3 on tree
Comment