I need a pair of steering arms from a front axle, preferrably a 108 g-10..... I'd also consider buying the spindles.....I appreciate any help I can get in locating and acquiring these parts...
-
-
AzDon
I'm not aware of any difference in the steering arms on the 108 vs the 90. I think they're the same on all the 2nd gen G10s, not sure about the G20s. The last time I saw a loose used spindle come up it went for $250 plus shipping. I haven't seen an NOS one in years. What's wrong with your spindle(s) and steering arm?
108VanGuy...1969 Chevy Panel, 250 CID, 3 ring 4 Spd. with OD, 2.73 "WedgieVan" Daily Driver
1967 Chevy Panel, 230 CID, 3 Spd. 3.36 "UtiliVan Owned since 76
1964 GMC Panel, 194 CID, 3 Spd. "CrunchoVan"
1965 Chevy Panel 350 CID, 3 Spd. "RustoRoof" Runs but wiring bad
1969 Chevy 108 Display 307 CID THM 350 Power Brakes 3.73 Posi
1965 Chevy Panel, V8, 3 Spd. "Gold Hills Van"
1965 CamperVan, V8, 3 Spd.
1969 G20 Shell -
I need the steering arms because I need to have the tapers re-drilled from the top down so the tie-rod can be on top so as not to interfere with the leaf springs (axle flip )....I still haven't found a machinist to do the work and I want to get all the parts done and ready before tearing into it.....
I didn't catch on at first that these goofy front leaf springs have about four degrees of negative caster before adding a severe front rake....If I had more huevos (and better equipment, I'd raise the front of the leafs and lengthen the shackles to roll in positive caster, but I'm trying small changes first...
Comment
Comment